Ken-tool 35935 Punch Replacement User Manual download pdf

Part No. 35935-98

PUNCH REPLACEMENT INSTRUCTIONS

Punch Replacement Kit #35935 contains:

1-punch (#35936-01),

1-spring (#35936-04),

1-slotted spring pin (#35936-05),

1- punch clip (#35935-10).

PUNCH IS SHARP – USE CAUTION!

1. Apply pressure against the old Punch with the Ram Bar to

compress the spring. Holding that position, attach the Punch Clip

(35935-10) to the punch, as shown.

2. Using a small hammer with a roll pin punch (or similar tool),

drive the Slotted Spring Pin out of the assembly.

3. Again, apply pressure against the Punch with the Ram Bar to

compress the spring. Remove the Punch Clip and allow the old

Punch and Spring to drop out of the Tube Assembly.

4. Place the new Spring onto the new Punch, and slide them

together, point-first, into the Tube Assembly.

5. Turn the tip of the new Punch until the drilled hole in its opposite

end shows in the slot of the Tube Assembly.

6. Apply pressure against the new Punch with the Ram Bar to

compress the spring. Holding that position, attach the Punch Clip

to the new Punch.

7. Using a small hammer, drive the new Slotted Spring Pin into and

through the new Punch until it protrudes evenly on both sides of

the Tube Assembly.

8. Again, apply pressure against the Punch with the Ram Bar to

compress the spring. Release the Punch Clip.

Part No. 35935-98 PUNCH REPLACEMENT INSTRUCTIONS Punch Replacement Kit #35935 contains: 1-punch (#35936-01), 1-spring (#35936-04), 1-slotted spri

No comments

Ken-tool 35935 Punch Replacement User Manual